Operation Manual

SEC-APC10

CEILING ALARM

With Remote Control

Description:

Figure A Figure B

Alarm Remote control

1. PIR sensor 8. Arm button

2. Siren 9. LED indicator

3. Infrared sensor 10. Disarm button

4. Battery LED indicator 11. Battery compartment

5. External power connection 12. Program switches

6. Mounting bracket 13. Battery cover

7. Battery compartment

ENGLISH

INSTRUCTIONS

PAGE 1
ENGLISH INSTRUCTIONS SEC-APC10 CEILING ALARM With Remote Control Description: Figure A Alarm Figure B Remote control 1. PIR sensor 2. Siren 3. Infrared sensor 4. Battery LED indicator 5. External power connection 6. Mounting bracket 7. Battery compartment 8. Arm button 9. LED indicator 10. Disarm button 11. Battery compartment 12. Program switches 13.
PAGE 2
Battery installation: Alarm: 1. The battery compartment is accessed from the rear of the alarm by removing the screws of the mounting bracket. 2. Insert 4x C size batteries (not included) according the correct polarity (see figure C) 3. When the batteries are inserted the alarm will beep very loud to indicate that the batteries are properly installed. 4. Replace the mounting bracket and fix it with the screws. The battery LED indicator will light when the batteries are LOW and need to be replaced.
PAGE 3
Installation: 1. Locate the desired location for the alarm on the ceiling in the center of the area that needs to be secured. 2. Remove the mounting bracket and fix this to the ceiling with screws. Then fix the alarm to the mounting bracket and secure this with the screws at the sides. Operation: Aim, when leaving the protected area, the remote control at the alarm and press the ‘ARM’ button. A confirmation tone will indicate that the alarm is armed and you have 30 seconds to leave the area.