Operation Manual

26
Name Description
1 Sensor ID Select Sensor ID which to be configured. Click on the
“Apply to all” will allow the user to configure all the
sensors at same time.
2 Alarming Specify the name of current sensor. The name will show
up on the Event Log List, and also the message box of
Main Monitor Panel.
3 Corresponding
Camera
Select the camera to be related with current sensor.
4 Enable Sensor
Detection
Click here to enable sensor detection .Click on the
“Schedule” to setup the week schedule of sensor
detection.
5 Delay Time The alarm will be triggered only after the sensor detection
is triggered continuously for the seconds specified here.
Note: This design is to avoid miss-trigger of sensor
detection event.
6 NC/NO NC(Normal Close): indicate sensor is normally at 0
NO(Normal Open): indicate sensor is normally at 1
7 Play Sound Play sound when motion detect event is triggered.
8 Video Clip Enable video recording in Event List Table. Refer to
“Chapter 4 Event Log Panel”
9 Alarm Output When sensor detected, the system will then trigger the
specified Alarm Output here.
10 Notifying
Personnel
User can specify which person to notify via E-Mail or
Phone or Mobile Phone.