Operation Manual

2
Watch Dog Connection
The Watch Dog Connection will allow the card to reboot the PC automatically when it
detects problems with the PC.
A) Connect the reset cable, which is connected with the motherboard, with the Watch
dog connection of the card.
B) Connect the supplied cable with the jumpers on the motherboard and the
Watchdog connection of the card.
See below figure:
4. Replace the PC’s cover and power cord and reboot the system.
5. When the Windows System reboots, the “New Hardware Wizard” dialog will appear.
Ignore the dialogue.
Note: In Windows XP the dialog will disappear after driver installation. In Windows
2000, you will need to close the dialogue manually.
6. Put the Installation CD into the CD-ROM. The Auto-run page will be displayed.
Click on “DVR SYSTEM INSTALL” and then the “DRIVER INSTALL” to automatically
install the driver.
A. PC Reset Button
Watch D o g
B. Supplied Watch
Dog cable
B. Jumpers on
Mother Board
A. PC reset cable