User Manual

14000 Drummer´s throne »Gomezz«
- Drummer´s throne for the professional: very sturdy and stable
- Adjustable in height by a notched system, 10 mm-steps from 475 min. to 675 mm max.
- Rotation of the seat individually and infinitely adjustable from easy going to firmly installed
- Perfect sitting comfort due to sophisticated upholstery and ergonomically shaped seat
- Fixed large rubber end caps with shock absorption
- Foldable, transport dimensions: seat 430 x 430 x 180 mm, leg construction 115 x 120 x 525 mm, 6.0 kg
SAFETY TIPS
- Max. 100 kg load capacity.
- Make sure the floor is suitable, sustainable, and level.
- The possibility to fold and to adjust the product bears the danger of
- squeezing. For this reason, cautious and considerate handling when
- setting up, using, and taking down is essential.
- The pull-button must always be locked in position.
- The grey clamping levers must be locked.
- The three legs must be folded out completely.
WARNING
SETTING UP INSTRUCTIONS
TECHNICAL DATA / SPECIFICATIONS
Material
Steel tubes and steel struts – chrome
Zinc die-casting – black powder coated
Clips - PA-6 black
Clamping levers – push-button - POM grey
Rubber end caps – Shore75A black
Upholstered
seat
imitation leather cover in grained soft-nappa, black
Load capacity Up to 100 kg
Height of throne min. 475 mm - max. 675 mm
Weight 6.0 kg
Optional
accessories
Art.-No. 14001-000-00
Holder with tuning key
Art.-No. 14002-000-00
Spikes set
- We are warning expressively to not climb up on the stool.
- The upholstered seat is not screwed to the extension rod but stuck on and clamped and might
- come off when being lifted. Therefore: Carry seat and leg construction separately, if not, hold
- both leg construction and seat at the same time.
- The rubber end caps are made of non-marring material. However, if necessary, a non-slip mat
- should be placed under the legs since they might leave marks on sensitive floors (for example,
- parquet).
- The use of optionally available spikes (Art.-no.14002) leads to imprints on the floor.
- Make sure all parts are there and in proper condition.
- Test the function of the movable parts.
LEG CONSTRUCTION
- Take the leg construction out of the box.
- Take the legs by the rubber end caps (1) and pull them apart.
- Push lower metal clip to the end (2) of the main tube.
UPHOLSTERED SEAT
- Take the seat out of the box.
- Open the grey clamping lever (3) at the bottom side of the seat.
- Put the seat on to the extension rod (4). Sit down immediately
- on the seat (5) . This leads to a tight fit of the seat and the rod.
- Lock the grey clamping lever (6) again.
Thank you for choosing this product. This instruction manual informs you about the important steps to set up and handle the product.
We recommend to keep the manual in a separate place for a possible later use.
root circle