User Manual

ASSEMBLY INSTRUCTION
KÖNIG & MEYER GmbH & Co. KG
Kiesweg 2, 97877 Wertheim, www.k-m.de
16085-000-55 Rev.10 03-80-302-00 5/15
AFFIXING the CLAMP
1 Table: Place the clamp on the table snuggly
1 Table: and tighten the finger screw.
2 Tube: Hold the clamp to the tube
2 Tube: and tighten the finger screw.
ASSEMBLY of the HOLDER
3 The holder is attached to the clamp using
3 finger screws 4 without the use of tools.
3 The clamp has 4 positions:
3 a. on the back, b. on top, c. and .d on both sides.
3 For both table and tube use the
3 holder can be adjusted accordingly
3 and up to 90° turn in each direction.
3 Altogether there are 15 possible
3 combinations.
FUNCTIONS
5 Form and material of the handle provide maximum
5 headphone protection
6 Two slits on the handle are for the secure
6 holding of the in-ear headsets
16085
Headphone Holder
with Table Clamp
- protective and stable headphone holder
- (rubber covered steel core)
- for up to 2 standard headphones plus 2 in-ear headphones
- the holder can be turned 90° in both directions and
- adjusts to the different positions of the clamp
- can be affixed to tables and tubes
- the clamp is easy on the surface
- clamp area of 0-52 mm
Thank you for choosing this product. This instruction manual informs
you about the important steps to set up and handle the product. We
recommend to keep the manual in a separate place for a possible later
use.
TECHNICAL DATA / SPECIFICATIONS
CHECK, MAINTENANCE, CLEANING
SAFETY NOTES
- In the event of workstation maintenance pay attention to possible
- risks (wedged in...)
- To care for the product use a damp cloth and a non-abrasive
- cleaning agent.
- Only use with suitable tables and stands, which based on their
- characteristics and stability are able to carry additional load.
- The flexibility of the individual component can result in wedging risk
- Careful and attentive handling during setup, operation, disassembly
- is indispensable.
- Ensure the screws are properly tightened.
Materials
holding angle: steel, black
housing: aluminum, powder coating black
clamp elements,
shell, handle: PA, rubber molding part, black
holder cushioning: TPE, black
Load capacity up to 2 headphones plus 2 in-ear-headsets
Dimensions
holder: inside 96 x 60 mm
clamp: 95 x 75 x 32 mm
overall: 190 x 60 x 120-173 mm
clamping area: table: 0 - 52 mm,
clamping area : tube: ø 6 - ø 42 mm
Packaging Box 78 x 35 x 132 mm
Weight 0.26 kg
Table:
max. 52 mm
Tube:
max. ø 42 mm