User Manual

ASSEMBLY INSTRUCTION
KÖNIG & MEYER GmbH & Co. KG
Kiesweg 2, 97877 Wertheim, www.k-m.de
16090-000-55 Rev.02 03-80-303-00 8/13
The product is ready for use and does not require
preparatory steps.
ATTACHING the CLAMP
1 DiThe table thickness may not exceed 45 mm.
2 Loosen the clamp screw as much as required.
3 Place the clamp on the table snuggly and re-tighten
3 the clamp screw
FUNCTIONS
4 Form and material of the handle provide maximum
4 protection of the headphone(s)
5 Two slits on the handle securely hold the in-ear
5 headsets
Thank you for choosing this product. This instruction manual informs
you about the important steps to set up and handle the product. We
recommend to keep the manual in a separate place for a possible later
use.
TECHNICAL DATA / SPECIFICATIONS
CHECK, MAINTENANCE, CLEANING
SAFETY NOTES
- in the event of workstation maintenance pay attention
- to possible risks (wedging)
- to care for the product use a damp cloth and a non-
- abrasive cleaning agent.
- Weight bearing load: up to 2 headphones plus 2 in-ear-
- headsets
- The clamp is designed to be attached to tables.
- The clamp is not designed to be attached to tubes.
- Only use with suitable tables that based on their charac-
- teristics and stability are able to carry additional load.
- The flexibility of the individual components can result in
- wedging risk. Careful handling during setup, operation,
- disassembly is indispensable.
- Ensure the clamp screw is tight
Material
Holding angle, clamp: steel, black
Clamp handle, cap: PA, rubber molding part, black
Holder cushioning: TPE, black
Load up to 2 headphones plus 2 in-ear-headsets
Dimensions
Headphone holders: inside 96 x 60 mm
U-Clamp depth: 43 mm, Width 30 mm
Clamping area: table: 0 - 45 mm
Packaging PE-bag 175 x 370 mm
Weight 0.205 kg
Plate:
max. 45
16090
Headphone holder
with table clamp
- protective and stable headphone holder
- (rubber covered steel core)
- for up to 2 standard headphones plus
- 2 in-ear headphones
- can be attached to tables
- the clamp is easy on the surface
- clamp area of 0-45 mm
FUNCTIONS
ATTACHMENT & DIMENSIONS