User Manual

KÖNIG & MEYER GmbH & Co. KG
Kiesweg 2, 97877 Wertheim, www.k-m.de
19797-000-55 Rev.04 03-80-088-00 1/18
TECHNICAL DATA
Material
Holder, joint: PA-6
Table base: Steel, pow. coating black
Screws: Steel, galvanized
max. load
Tablets
Height: min. 163 mm, max. 242 mm
Width: min. 102 mm, max. 189 mm
Depth: min. 5 mm, max. 11 mm
Dimensions
Stand with Holder W x D x H
180/257 x 145 x 236/308 mm
Packaging W x D x H: 243 x 144 x 262 mm
Weight net 1.3 kg, gross 1.6 kg
SETUP
FAULT-FINDING (F) and REPAIR (R)
F: Holder is unstable
F: R: Check the screws and tighten, if needed.
F: Tablet is not securely in place
F: R: Correct the position of the side support
F: R: arms, so that the corner supports are pro-
F: R: perly set on the Tablet without any play 2-9
F: R: Ensure that the lower support arms
F: R: setting are symmetrical 4,5. Asymmetric
F: R: setting of the support arms looks bad and
F: R: does not ensure that the Tablet is
F: R: securely held in place.
F: R: Do not only place the Tablet on the upper
F: R: support arm, but be sure it clicks into place 8,9.
F: R: Observe the minimum i.e maximum
F: R: dimensions 22.
USAGE NOTES and FUNCTIONS
The angle, direction and format of the
tablet can be adjusted. The (securely
positioned) Tablet does not have to be
removed from the holder.
ANGLE (16-18)
The Tablet can be adjusted to
any final position by adjusting it
vertically and horizontally. To do this:
16 Hold the Tablet and loosen the wing nut
somewhat
17 Pick the position (vertical / horizontal) and...
18 ...re-tighten the wing nut.
FORMAT (19)
The holder has a 90°-Twist Function.
This allows the Tablet to be presented in
landscape or portrait.
19 Take the holder and turn it to the landscape,
19 portrait or tilted position!
NOTE- Hitches within the mount limit how far
the holder can be turned.
REMOVING the Tablet (10-12)
10 Loosen the three knurled pins a bit
11 Hold the tablet and LIFT UP the catch
12 Flip out the Tablet and REMOVE
If you always use the same tablet, we recom-
mend, recommend that the support arm
settings remain in this position. Or remember
or mark at least the scale values.
REPEATED PLACEMENT of the
Tablet (13-15)
For previously set support arms
13 Place the tablet in the lower corner supports
14 Place the tablet into the upper catch
14 and gently press until you can hear it
14 click into place
15 Tighten the knurled pins until the tablet is
15 gently pressed into place
Then check that the Tablet is secure as
described in 9.
ANGLE & DIRECTION (16-18)
FORMAT (19)
DIMENSIONS
REMOVING the Tablet (10-10)
REPEATED PLACEMENT of the Tablet (13-15)
Final Position
- horizontal
- as far as it goes
Final Position
- vertical
- as far as it goes
Interim Position:
- tilted (0-90°)
- select any position (Secure position
- by tightening the wing nut 18)
Final Position
-landscape
- clicked into place
Final Position
portrait
- clicked into
- place
Twist (Interim Position):
- tilted
- not clicked into place, however it
- does stay in the selected position