User Manual

ATTACHING & MOVING of the LOAD
- NOTE!
Do not undervalue the weight of the load.
- Attaching and moving of the load should be done by trained installers
- While moving the load hold the extension in a safe and firm way.
- Secure the extension with the locking pin.
- NEW: the extension ends in a cone.
- NEW: This would be helpful to attach the load.
MAINTENANCE
MOVING
Involved Persons:
FI - First Installer:
holds the loaded extension
SI - Second Installer:
handles locking knob and locking pin
Action:
FI
1 holds the extension firmly
SI
2 loosens the locking knob
3 pulls the head of the locking
6 pin until the extension is
6 able to move
FI
4 lifts the extension in
7 desired height
7 NOTE: for easier finding of
7 the pin hole this hole should
7 be seen for a moment above
7 the clamp
SI
5 unhands the head of the
8 locking pin so it´s able to
8 atch into the hole of the
8 extension
FI
6 lowers the extension
9 slowly until the locking
9 pin is latching into the
9 hole
SI
7 tightens the locking knob
Remove the load in reverse order.
- Handle the stand with care.
- Maintain only in unloaded mode.
-For cleaning use a damp cloth and
- a non-abrasive cleaner.
(D) DEBUGGING & (R) REPAIR
D: stand totters:
D: R: Arrange an even ground.
D: R: Spread legs into max. width and
D: R: tighten the locking knob
D: Extension totters and/or is running in:
D: R: Make sure that the locking pin is in
D: R: work and tighten locking knobs.