User Manual

-During maintenance work, watch out for possible injuries.
-For cleaning it is best to use a damp cloth and a mild, non-
-abrasive detergent.
FAULT FINDING and REPAIR
-Control-1 sits loosely on U-bracket and fixing bracket:
-a. Tappet of the U-bracket (3) has not locked in the hole of the
-a. fixing bracket (4):
-a. = Push parts together until tappet has locked in place
-a. = audibly and visibly; tighten nut.
-b. Rubber coating on U-brackets and/or fixing brackets is
-b. missing:
-b. = Re-order spare part no.03-21-900-55.
-Box tilts forward by itself:
-a. Screws (5.c) are not tightened enough:
-a.= tighten screws.
ASSEMBLY
-Place Control-1 with U-bracket (3) on to
-the support arm (2) and use the two
-M6x16 screws (5.c) to screw it on tightly.
-Attention: If necessary, two people should
-Attention: perform this task.
G
MEASUREMENTS
H
USER TIPS / FUNCTION
CHECKING, MAINTENANCE, CLEANING
J
TURNING
-Take off cap and loosen nut M6 (5.a).
-Turn Control-1 in the desired direction and
-tighten nut again; put cap back on.
K
TILTING
-Hold box tight and loosen both screws (5.c).
-Place box in the desired position and tighten both
-screws again.
TECHNICAL DATA / SPECIFICATIONS
Material
steel tubes and steel sheets - black powder coated
caps - Polyamide 6, black
Max. Load Capacity JBL-Control 1 (2.3 kg)
Measurements width 85 mm, depth 153 mm, height 135 mm
Weight 0.6 kg
KÖNIG & MEYER GmbH & Co. KG
Kiesweg 2a, 97877 Wertheim, www.k-m.de
24465-000-55/57 Rev.16/17 03-80-340-00 7/20