Data Sheet

Manufactured by :
CRC Industries Europe NV
Touwslagerstraat 1 – 9240 Zele – Belgium
Tel (32) (0) 52/45.60.11 Fax (32) (0) 52/45.00.34
www.crcind.com
TECHNICAL DATA SHEET
1/2
KONTAKT PCC
Ref. : 20840
1. GENERAL DESCRIPTION
Cleaner and flux remover for printed circuit boards. Special mixture of organic solvents, free
from CFC and HCFC. Comes with an add-on brush-type spray head.
2. FEATURES
KONTAKT PCC is a special cleaner for removing flux remains and dirt on printed circuit
boards having the following characteristics :
• High cleaning power due to its special solvent mix
• Quick and residue-free surface drying
• Firm and time gaining cleaning due to the brush-type spray head
• Compatible with markings and colour codes
Kontakt PCC results in clean printed circuit boards and hence in high surface resistivity, low
leakage current and good adhesion of conformal coatings.
3. APPLICATIONS
KONTAKT PCC is used to clean printed circuit boards and other electronic components. It is
also used before and after soldering and repair works and in the preparation of the surface
prior applying conformal coatings or protective stickers.
4. DIRECTIONS
• The aerosol can has been fit with a brush-type spray head to help the cleaning by
mechanical means. The aerosol can be used in an upside-down position (360° valve) for
hard to reach areas. As carbon dioxide is used as propellant it was possible to fill the
aerosol can with ±95% active product.
• For minor cleaning operations it is possibly enough to rinse the printed circuit board with
KONTAKT PCC. Brushing of course supports the cleaning. To remove residues of flux,
first wet the brush and than spray the product on while brushing with a gentle pressure
over the printed circuit board. In doing so, hold the board as vertical as possible and
work, from top to bottom. For optimum results, it is best to re-rinse the surface with
KONTAKT PCC.
• If a “whitish deposit” forms on the printed circuit board after cleaning, this might mean
there was probably a coating present which has been partially dissolved by KONTAKT
PCC. In this case a perfect appearance is restored to the circuit board by coating it with
our conformal coating PLASTIK 70.
• KONTAKT PCC has been tested for compatibility with PCB materials, solder-stop varnish
and electronic components. In particular it has been found that colour codings are not
damaged by KONTAKT PCC. There are only a few very sensitive plastics which are