User's Manual Part 3

BIOS Messages
The following is a list of the messages that the BIOS can display. Most of them occur during POST. Some of them
display information about a hardware device, e.g., the amount of memory installed. Others may indicate a problem
with a device, such as the way it has been configured.
Following the list are explanations of the messages and remedies for reported problems. *If your system displays one
of the messages marked below with an asterisk (*), write down the message and contact Kontron Technical Support.
If your system fails after you make changes in the Setup menus, reset the computer, enter Setup and install Setup
defaults or correct the error.
0200 Failure Fixed Disk
Fixed disk is not working or not configured properly. Check to see if fixed disk is attached properly. Run Setup.
Find out if the fixed-disk type is correctly identified.
0210 Stuck key
Stuck key on keyboard.
0211 Keyboard error
Keyboard not working.
*0212 Keyboard Controller Failed
Keyboard controller failed test. May require replacing keyboard controller.
0213 Keyboard locked - Unlock key switch
Unlock the system to proceed.
0220 Monitor type does not match CMOS - Run SETUP
Monitor type not correctly identified in Setup
*0230 Shadow Ram Failed at offset: nnnn
Shadow RAM failed at offset nnnn of the 64k block at which the error was detected.
*0231 System RAM Failed at offset: nnnn
System RAM failed at offset nnnn of in the 64k block at which the error was detected.
*0232 Extended RAM Failed at offset: nnnn Extended memory not working or not configured properly
at offset
nnnn.
0250 System battery is dead - Replace and run SETUP
The CMOS clock battery indicator shows the battery is dead. Replace the battery and run Setup to reconfigure the
system. Note: ReVolution’s CMOS battery is rechargeable and should never need replacement.
0251 System CMOS checksum bad - Default configuration used
System CMOS has been corrupted or modified incorrectly, perhaps by an application program that changes data
stored in CMOS. The BIOS installed Default Setup Values. If you do not want these values, enter Setup and enter
your own values. If the error persists, check the system battery or contact KMC.
*
0260 System timer error
The timer test failed. Requires repair of system board.
*0270 Real time clock error
Real-Time Clock fails BIOS hardware test. May require board repair.
0271 Check date and time settings
BIOS found date or time out of range and reset the Real-Time Clock. May require setting legal date (1991- 2099).
0280 Previous boot incomplete - Default configuration used
ReVolution User Manual 1.00 02/25/03 67