Instruction Manual

AT8904M Routing Commands
Page 3 - 23 AT8904M CLI Reference Manual
3.6.2.1 no bootpdhcprelay enable
This command disables the forwarding of relay requests for BootP/DHCP Relay on the
system.
Format
no bootpdhcprelay enable
Mode Global Config
3.6.3 bootpdhcprelay maxhopcount
This command configures the maximum allowable relay agent hops for BootP/DHCP
Relay on the system. The
<hops> parameter has a range of 1 to 16.
Default 4
Format
bootpdhcprelay maxhopcount <1-16>
Mode Global Config
3.6.3.1 no bootpdhcprelay maxhopcount
This command configures the default maximum allowable relay agent hops for BootP/
DHCP Relay on the system.
Format
no bootpdhcprelay maxhopcount
Mode Global Config
3.6.4 bootpdhcprelay minwaittime
This command configures the minimum wait time in seconds for BootP/DHCP Relay
on the system. When the BOOTP relay agent receives a BOOTREQUEST message, it
MAY use the seconds-since-client-began-booting field of the request as a factor in
deciding whether to relay the request or not. The parameter has a range of 0 to 100
seconds.
Default 0
Format
bootpdhcprelay minwaittime <0-100>
Mode Global Config
3.6.4.1 no bootpdhcprelay minwaittime
This command configures the default minimum wait time in seconds for BootP/DHCP
Relay on the system.
Format
no bootpdhcprelay minwaittime
Mode Global Config
3.6.5 bootpdhcprelay serverip
This command configures the server IP address for BootP/DHCP Relay on the system.
The <
ipaddr> parameter is an IP address in a 4-digit dotted decimal format.
Default 0.0.0.0
Format
bootpdhcprelay serverip <ipaddr>
Mode Global Config