Instruction Manual

Routing Commands AT8904M
AT8904M CLI Reference Manual Page 3 - 30
Format area <areaid> virtual-link <neighbor> hello-interval <1-
65535
>
Mode Router OSPF Config
3.7.18.1 no area virtual-link hello-interval
This command configures the default hello interval for the OSPF virtual interface on
the virtual interface identified by
<areaid> and <neighbor>. The <neighbor>
parameter is the Router ID of the neighbor.
Format
no area <areaid> virtual-link <neighbor> hello-interval
Mode Router OSPF Config
3.7.19 area virtual-link retransmit-interval (OSPF)
This command configures the retransmit interval for the OSPF virtual interface on the
virtual interface identified by
<areaid> and <neighbor>. The <neighbor> parameter
is the Router ID of the neighbor. The range for seconds is 0 to 3600.
Default 5
Format
area <areaid> virtual-link <neighbor> retransmit-interval
<seconds>
Mode Router OSPF Config
3.7.19.1 no area virtual-link retransmit-interval
This command configures the default retransmit interval for the OSPF virtual interface
on the virtual interface identified by
<areaid> and <neighbor>. The <neighbor>
parameter is the Router ID of the neighbor.
Format
no area <areaid> virtual-link <neighbor> retransmit-inter-
val
Mode Router OSPF Config
3.7.20 area virtual-link transmit-delay (OSPF)
This command configures the transmit delay for the OSPF virtual interface on the
virtual interface identified by
<areaid> and <neighbor>. The <neighbor> parameter
is the Router ID of the neighbor. The range for seconds is 0 to 3600 (1 hour).
Default 1
Format
area <areaid> virtual-link <neighbor> transmit-delay <sec-
onds
>
Mode Router OSPF Config
3.7.20.1 no area virtual-link transmit-delay
This command resets the default transmit delay for the OSPF virtual interface to the
default value.
Format
no area <areaid> virtual-link <neighbor> transmit-delay
Mode Router OSPF Config