Instruction Manual

AT8904M Management Commands
Page 6 - 9 AT8904M CLI Reference Manual
6.3.6 session-timeout
This command sets the Telnet session timeout value.The timeout value unit of time is
minutes. A value of 0 indicates that a session remains active indefinitely.
Default 0
Format session-timeout <0-160>
Mode Line Config
6.3.6.1 no session-timeout
This command sets the Telnet session timeout value to the default. The timeout value
unit of time is minutes.
Format no session-timeout
Mode Line Config
6.3.7 telnetcon maxsessions
This command specifies the maximum number of Telnet connection sessions that can
be established. A value of 0 indicates that no Telnet connection can be established. The
range is 0-5.
Default 5
Format telnetcon maxsessions <0-5>
Mode Privileged EXEC
6.3.7.1 no telnetcon maxsessions
This command sets the maximum number of Telnet connection sessions that can be
established to the default value.
Format no telnetcon maxsessions
Mode Privileged EXEC
6.3.8 telnetcon timeout
This command sets the Telnet connection session timeout value, in minutes. A session
is active as long as the session has not been idle for the value set. The time is a decimal
value from 1 to 160.
NOTE: When you change the timeout value, the new value is applied to all
active and inactive sessions immediately. Any sessions that have been
idle longer than the new timeout value are disconnected immediately.
Default 5
Format telnetcon timeout <1-160>
Mode Privileged EXEC
6.3.8.1 no telnetcon timeout
This command sets the Telnet connection session timeout value to the default.