Manual

D R A F T — F O R I N T E R N A L U S E O N L Y
17
www.kontron.com
User Guide
CPS3003-SA
LEDs / Switches
Front Panel LEDs System Status LEDs:
» HS (blue): Hot Swap Status
» TH (red/green): Temperature Status
» WD (green): Watchdog Status
General Purpose LEDs:
» LED3..0 (red/green/red+green): General Purpose / POST Code
Ethernet LEDs:
» ACT (green): Network /Link Activity
» SPEED (green/orange): Network Speed
DIP Switch One DIP switch, SW1, for board configuration
Timer
Real Time Clock Real-time clock with 256 Byte CMOS RAM; battery-backup available
Watchdog Timer Software-configurable, two-stage Watchdog with programmable timeout ranging
from 125 ms to 4096 s in 16 steps
Serves for generating IRQ or hardware reset
Sys. Management
Thermal Management CPU and board overtemperature protection is provided by:
» Up to four Digital Thermal Sensors (DTS), one for each core
» One Digital Thermal Sensor (DTS) for the processor graphics controller
» One temperature sensor integrated in the Intel® QM77 Chipset for monitoring
the chipset
» Specially designed heat sinks
Security
TPM Trusted Platform Module (TPM) 1.2 for enhanced hardware- and software-based
data and system security
Software
uEFI BIOS AMI Aptio® BIOS firmware based on the uEFI Specification and the Intel Platform
Innovation Framework for EFI:
» LAN boot capability for diskless systems (standard PXE)
» Redundant image; recovery possible in case of a damaged image
» Non-volatile storage of setting in the SPI boot flash (battery only required for
the RTC)
» Compatibility Support Module (CSM) providing legacy BIOS compatibility
based on AMIBIOS8
» Command shell for diagnostics and configuration
» uEFI Shell commands executable from mass storage device in a Pre-OS envi-
ronment (open interface)
Operating Systems There are various operating systems available for the CPS3003-SA. For further
information, please contact Kontron.
Table 1: CPS3003-SA Main Specifications (Continued)
FEATURES SPECIFICATIONS