User guide

ID 1022-8317, Rev. 2.0
Command SupportNetBootLoader
Page 19
3. Product Command Support
The following table provides a complete listing of all NetBootLoader commands. Each Kontron
product which employs the NetBootLoader is shown along with a matrix entry indicating the ap-
plicability of the command for the product. As can readily be seen, not all commands are appli-
cable to a given product, and, in some cases, commands available depend on the operational
mode or configuration of the product indicated.
LEGEND:
AMC use this version of the command for addressing the AMC products indicated
ASMP only available when product is operated in the asymmetric multiprocessing mode
SMP only available when product is operated in the symmetric multiprocessing mode
FTP use this version of the command for addressing the FTP server
NAND use this version of the command (when logged into an FTP server) to address the
NAND Flash
1/2-NBL-FL use of the command version depends on availability of NBL Flashes - one or two
NBL-FL this command only addresses the NBL Flash(es)
NAND-FL this command only addresses the NAND Flash
NON-AMC use this version of the command for addressing non-AMC products
Table 6: Command / Product Table
PRODUCTS
NETBOOTLOADER
COMMANDS
AM4100 AM4101 CP320 CP321 CP620 CP6200 EB405 EB425 EB8245 EB8347 EB8540 EB8541 EB860 VMP1 VMP2 VMP60 DX11
ABORT XXXXXXXXXXXXXXXXX
ASSIGN (ASMP) X X
ASSIGNMEM (ASMP) X X
BL X X
BW XXXXXXXXXXXXXXXXX
BYE XXXXXXXXXXXXXXXXX
CBL X X X X X X X X
CD (FTP)XXXXXXXXXXXXXXXXX
CD, CDCF (NAND) X X
CHECK XXXXXXXXXXXXXXXXX
CLONE (1-NBL-FL) XXXXXXXXXXXXXXX
CLONE (2-NBL-FL) X X