KON4817 Kosmik HV-I Instruction Manual

25
Please note: For the KOSMIK HV-I Variants
only the two outer sensor ports can be used.
It is not possible to use the middle sensor
port for Buetooth module.
If you want to pair the Bluetooth module to your
KOSMIK ESC please follow the steps in the
Bluetooth module manual. You can find the
lastest Version of the manual on our website:
www.kontronik.com.
11. Logging
KOSMIK ESC operates with an internal record of
parameters. The following parameters are stored in
a file:
• Motor start / Motor stop
• Motor speed (RPM)
• Battery voltage (V)
• Discharge capacity (mAh)
• Motor current (A) / Peak current (A)
• Temperature (°C)
• PWM (%)
• Throttle position (%)
• BEC voltage (V) / BEC current (A)
• BEC temperature (°C)
The recorded data is stored in a DAT formatted
file and can be opened and processed by using a
text editor. The logging of data starts altogether
with the motor start. It ends with plugging off the
battery.
Please note that only high-quality Micro SD cards
can be used for recording. Inferior Micro SD cards
with slower processing time can result in no data
storage. We recommend using the SD card on
every flight in order to analyze possible
rootcauses.
12. Troubleshooting
Basically:
The KOSMIK shows by the flashing of the LEDs
the possible problems.
Problem
LED1
LED2
Motor off position not
detected
flashing green flashing green
Programming invalid
constant green
constant green
Error during
self
-
test
flashing red
off
Error in use
flashing red
flashing red
Warning in use
flashing red
flashing green
Info
in
use
off
off
The exact error reason is documented on the SD
card. Once it is written during logging and can be
found in the log file. On the other side there is an
error.dat file which includes all documented
messages of the log files.
Which error message what consequences have
you can find in the appendix of this manual.
13. Technical support, Advice, Hotline
Tel.: [phone]
Fax: [phone]
Email: [e-mail]
Web: www.kontronik.com
The latest KONTRONIK product
information, FAQs and support times can
be found on the KONTRONIK homepage:
www.kontronik.com
13.1 Recycling
Electronic components must not be disposed with
household waste but must be disposed according to
legal and environmental regulations. National and
local disposal regulations must be respected!
13.2 Warranty
SOBEK Drives guarantees that this product is free
of factory defects in material and workmanship for a
period of 24 months from date of purchase and
purchase within the EU. Warranty for purchases
made outside the EU is in line with the respective
legal regulations.
This warranty does not cover: suitability for specific
application, components worn by use, application of
reverse or improper voltage, tampering, misuse or
shipping.
Our warranty liability shall be limited to repairing or
replacing the unit to our original specifications.
Because we have no control over the installation or
use of these products, in no case shall our liability
exceed the original cost of the product.
All warranty claims terminate with opening of the
product.
To accept warranty the original bill on which the
product the date of purchase and the dealer is
named must be sent together with the product.
Also, a detailed fault description is necessary
and should include:
· used motor,
· propeller diameter
· number and type of batteries
· time of failure
Please use the KONTRONIK service form for
sending in to:
SOBEK Drives GmbH
Am Oberfeld 9
D- 72108 Rottenburg am Neckar
Germany
Do not forget to write your address on the
package, in capital letters!
!
!
!