Specifications

48V POE
48V POE
4
Option 1: Connect doorbell to WiFi and 12V power supply.
5
6
Option 2 (recommended): The network cable is connected to a standard
12V POE switch, The length of the network cable is less than 100 meters.
Outdoor
6
Reset
LAN1 LAN2 LAN3 LAN4 WAN
5
Use the drill bit to drill three holes. One hole is large enough to pass through
the LAN cable,
use anchors if you install video doorbell on brick or concrete.
7
7
1. Remove the screws of the rain cover
2. The rain cover is separated from the doorbell
3. Insert the TF card
4. Fix the rain cover with two screws
5. Plug the DC cable into the power socket
6. Pass the DC cable through the hole on the wall
7. Plug the rain cover on the host and fix the bottom screws.
8. Connect the 12V power supply to the female end of the DC cable
3
1
4
5. Connect the network cable to the network port of the doorbell
6. Plug the rain cover on the doorbell and fix the bottom screws
7.
Connect the doorbell via LAN Cable at RJ45 port to POE injector and into Router.
Diameter >1.5cm
Outdoor
Outdoor
Indoor
Outdoor
Indoor
Make sure that have a strong WiFi connection at the location of video doorbell.
Reset
LAN1 LAN2 LAN3 LAN4 WAN
DC 12V
POE connect