User guide

The Koolance ADT-FM002P allows a Molex 4-pin 12V PSU connection to power LED lighting of Koolance INS-FMxx Flow
Meters. It also multiplies the fl ow meter RPM signal to allow it to be read by most fan tachometer headers (such as those found
on ATX motherboards).
The fl ow meter RPM reading is intended to allow fan detection software (including BIOS) to enable the appropriate alarm or
shutdown procedure if the fl ow meter impeller stops rotating. The “RPMs” represent approximate coolant fl ow rate in mL/min,
and not revolutions.
The required connections for ADT-FM002P are illustrated below. CAUTION: Make sure to properly insulate the circuit from
chassis ground, or permanent damage can occur to the circuit and/or fl ow meter.
Koolance ADT-FM002P Installation Guide v1.00
1
Coolant fl ow meter LED
switch: off, on, pulse
(according to fl ow rate)
Motherboard signal connection
12V 4-pin Molex
power supply connection
Coolant fl ow meter
(sold separately)
Meter liquid fl ow
compensation
(10-13mm & 6mm ID)
The Koolance ADT-FM002P allows a Molex 4-pin 12V PSU connection to power LED lighting of Koolance INS-FMxx Flow
Meters. It also multiplies the fl ow meter RPM signal to allow it to be read by most fan tachometer headers (such as those found
on ATX motherboards).
The fl ow meter RPM reading is intended to allow fan detection software (including BIOS) to enable the appropriate alarm or
shutdown procedure if the fl ow meter impeller stops rotating. The “RPMs” represent approximate coolant fl ow rate in mL/min,
and not revolutions.
The required connections for ADT-FM002P are illustrated below. CAUTION: Make sure to properly insulate the circuit from
chassis ground, or permanent damage can occur to the circuit and/or fl ow meter.
Koolance ADT-FM002P Installation Guide v1.00
1
Coolant fl ow meter LED
switch: off, on, pulse
(according to fl ow rate)
Motherboard signal connection
12V 4-pin Molex
power supply connection
Coolant fl ow meter
(sold separately)
Meter liquid fl ow
compensation
(10-13mm & 6mm ID)