User`s manual

16
Hose Lengths
Before installing your liquid coolers, appropriate lengths of tubing must be cut to
connect each device. It may be easier to temporarily lay your motherboard and
video card inside the case to better-estimate the required amounts.
Generally, the outlet of the radiator will connect with your CPU Cooler, but this is
completely optional. The reservoir and pump unit may be located before or after the
radiator, depending on the preferred arrangement of water blocks.
With one of the connected
hoses, roughly estimate the
length you will need to your
fi rst cooler, and cut it.
Cut the second hose with
enough length to connect
with the last cooler that will
be in your system.
Using the leftover tubing,
cut shorter pieces to link
between each individual
cooler and/or hose splitter.
Connecting PC4-1000 Systems
NOTE: When fi lling the reservoir later, it will need to be pulled out from the front
chassis drive bay by about 2.75” (7cm). Be sure to leave enough tubing between
the reservoir unit and connected cooler to do this.