Installation Guide

Warranty
This KOOLATRON product is warranted to the retail customer for 90 days from
date of retail purchase, against defects in material and workmanship.
WHAT IS COVERED
• Replacement parts and labour.
• Transportation charges to customer for the repaired product.
WHAT IS NOT COVERED
• Damage caused by abuse, accident, misuse, or neglect.
• Transportation of the unit or component from the customer to Koolatron.
IMPLIED WARRANTIES
Any implied warranties, including the implied warranty of merchantability are also
limited to the duration of 90 days from the date of retail purchase.
WARRANTY REGISTRATION
Register on-line at www.koolatron.com AND keep the original, dated, sales receipt
with this manual.
WARRANTY AND SERVICE PROCEDURE
If you have a problem with your PRODUCT, or require replacement parts, please
telephone the following number for assistance:
North America 1-800-265-8456
Koolatron has Master Service Centres at these locations:
Koolatron U.S.A.
4330 Commerce Dr.
Batavia, NY 14020-4102 U.S.A.
Koolatron Canada
27 Catharine Ave.
Brantford, ON N3T 1X5 Canada
A Koolatron Master Service Centre must perform all warranty work.
www.koolatron.com
©2009 Koolatron, Inc. All rights reserved.All specification are subject to change without notice.
Made in China
10/2009-v2H1S087
Please Read These Instructions Carefully Before Use!
Installation Manual
84-GALLON POND KIT
KSPK-84
ASSEMBLING YOUR PUMP
1
2
4
7
5
6
3
Place desired fountain head (1) on riser (2)
pushing down until snug.
Adjust the size of the waterbell by turning
the round piece (3) on top.
Put riser (2) into diverter (4), pushing down
until the hole is no longer visible.
Some light force may be required.
Adjust the flow of water to your fountain
head by turning the diverter knob (5).
Attach all to the pump (6) by pushing
down the diverter into the hole located on
top of the pump (6).
FOR A HIGHER FOUNTAIN HEAD
• Extend the tube extention (7) found
inside the riser (2).
FOR A WATERFALL
• Place clamp over tubing.
• Fit tubing over diverter.
• Tighten clamp over tubing with a Flat
Head Screwdriver.
Note
Do NOT plug in your pump until it is fully immersed in water. Never run your pump dry!