BACK BAR COOLER CONTENTS ® IN CASE OF THE FLOWING ® BEFORE REQUESTING SERVICE Please read these instructions completely before operating the units.
SAFETY PRECAUTIONS @ To ensure proper use, please thoroughly study these SAFETY PRECAUTIONS before operating the Unit. ® The purpose of the safety precautions in this manual is to ensure safe and correct use of the unit to minimize risks that could cause serious damage and injury to you or other persons, The safety precautions are divided into WARNINGS and CAUTIONS. Cases where improper handing of the unit could lead te death or serious Injury are listed under the WARNING' heading.
SAFETY PRECAUTIONS A WARNING The cooler Is Intended for storage and display of beverages for sale. Do not use for other purpose than intended os this could 0 Never attempt to Insert fingers, sticks, efc. Into the cold air suction outing as a circulation fan is rotating at high speed Inside the outlet. performed, the unit could fip over and dwelling shelves and products could cause personal Injury. | JON 4 z QD adversely affect items placed in the unit.
SAFETY PRECAUTIONS A WARNING It installation in a damp location is WELL VENTILATED PLACE unavoidable, also Install an electrical Please make sure short is more lanthanum space between | mere leakage circuit breaker. If no electrical EH leakage circulate breaker Is Installed, UPRIGHT cooler And the wall. If there is no space, cooling capacity can drop down. ant ») 7 Never hang from the door or climb onto Disconnect the power cord plug from the the unit.
HOW TO USE +Remove shipping package, tape, etc, and leave doors open ventilate for a while. es The unit is cleaned before shipment. However, clean the compartment interior after delivery. e Please Insert power supply plug Into the wall outset single-phase to cat voltage. *Allow the unit 10 operate for about 1 hour to cool the compartment before placing Items In the cooler.
HOW TO USE « Defrosting Is performed automatically and drain water is collected in the drain fray. * Water in the drain tray is evaporated automatically. In humidity, there is a large amount of water in the drain tray, so please throw away drain water once a day. * To prevent cold air from escaping, open and close the door quickly and keep the door opened for as short a ime as possible. * Please Install the unit In the place which Is well-ventilated. The shelf height can be adjusted.
IN CASE OF THE FOLLOWING Keep opening and closing of the door to a minimum. Avoid placing new Items In the cooler as this will reals the temperature Inside the compartment. Remove all Items from the compartment and disconnect the power cord plug from the wall outset. Clean the compartment Interior and wipe away all water. To prevent mood formation and bad smell, leave the door open 1o dry the compartment completely. Disconnect the power cord plug from the wall outlet.
BEFORE REQUESTING SERVICE ~ No refrigeration natal @Is the power supply Interrupted? ®Is the power cord plug disconnected from the wall outlet? @Are the shop's power fuses blown and/or the circuit breaker activated? Inadequate refrigeration @1s the temperature setting appropriate? @ Are items obstructing the cold air inlet and suction outset? @ Are stored items packed foo tight? @ Is the door open or Is It opened and closed frequently? @ ls the condenser clogged? Excessive nose @ Are all feet in firm contac