Installation Guide

4. Screw the regulator cap back into the regulator and reattach the regulator to the

nipple and fla e union.

STEP 2 - CHANGE BURNER ORIFICES

IMPORTANT: Carefully read and observe each orifice label or correct location. See

the Burner Chart earlier in this section.

NOTE: First remove all orifices and then start eplacing them. This will help avoid the

possibility that some may not be replaced.

1. Remove the burner grates, burner caps and burner heads.

2. Using a 7 mm nut driver, remove the burner orifices

a Orifice

Triple Ring Burner

5 Orifice

Auxiliary Burner

Semi-Rapid Burner

Rapid Burner

1 Orific Each

3. Install the proper orifices in the exact locations as n ted in the previous graphic.

4. Replace the burner bases, heads, caps and top grates. Make sure burner caps are

properly seated on the burner head.