Use and Care Manual

STEP 1: Remove the
tape first
Water inlet port on
the unit back
STEP 2: Insert the
water hose
Then install
back the clipper
White water
hose(accessory)
First insert the
water hose inward
completely
Remove the
clipper first
Connect the water supplying hose to the unit
Step 1:First remove the tape on the water inlet port for water supply (indicated in the following illus-
tration “B”) located at unit back, then use your other hand’s finger to press the out circle.
Step 2: Insert the one end of the white water hose into the water inlet port, and push inward complete-
ly, and install back the clipper, then water hose connection is completed.
Connecting the water drain pipe
Pull out the water drainage cap with black color (indicated “A” in Fig.6), then connect the white drain-
age pipe included in accessory, again connect the other end of this drainage to the main water drain-
age pipeline.
Connect the water hose to the water faucet of the water main supply system
First, install the supplied water quick-connector to the water faucet by screw thread; Second, remove
the clipper from the water quick-connector, insert the another end of the water hose into this
quick-connector port completely, then install back the clipper, also this step is completed. Note: The
water faucet should be supplied by the customer himself.
Important: The water pressure of main water supply system must be 0.04-0.6 MPa at least.