Use and Care Guide
Modular Ice Maker User Manual for Installation and Maintenance
1. Check if the ice machine is in good
condition and the accessories are
complete; check the machine model and
the machine nameplate.
2. Clean the ice bin and the food area inside
with a sponge soaked in warm water and
soap. Then wash and dry it with potable
water.
3. Place the ice machine in the operation
area; ensure that the machine is placed on
a leveled floor. So as to ensure the water
flows evenly on the evaporator.
4. The compressor chamber is located at the
back. The compressor and condenser are
installed in it. For air cooled unit, it requires
good ventilation. Therefore, the front and
rear of the ice maker must have ventilation
space of more than space of more than 8”
in the rear, 6” on the sides, and 12” in the
front
5. The bottom of the ice machine is equipped
with adjustable legs for level adjustment
and floor cleaning.
6. Connect the machine's inlet water filter
and water pipe referring to the schematic
diagram of installation; if the installation
site is already equipped with a drinking
water system, the water filter may not be
installed.
7. Connect the machine to the water supply
using the 3/4" inlet pipe supplied with the
machine. It is recommended to install a
water valve (not supplied with this
machine) on the water supply line.
8. Connect the drain pipe to the drain
connection. In order to meet a good
draining, it is recommended that the drain
pipe should have a difference of level
more than 1” per 3’; and confirm that the
drain pipe is not blocked. It is
recommended that the drain pipe be
connected to an open drainage port.
9. Any joint in the drain pipe must not be
higher than the machine drainage port;
any joint in the drain pipe cannot be higher
than the previous joint.
10. Confirm the power requirements stated in
the machine nameplate; ensure that the
power supply meets the requirements.
11. A circuit breaker or switch with leakage
protector and reliably grounding is
required.
12. Turn off the switch on the power line and
connect the machine to the power source.
1. Before you start up the machine, please
check and confirm:
• That the packaging tape inside the ice
machine has been removed;
• The accessories or items in the ice bin
have been taken out;
• The ice machine has been adjusted to a
leveled state;
• The water pipe has been connected and
the water valve is open;
• The plug has been connected to the power
supply and the power switch is off.
• The ambient temperature, water
temperature, and pressure of the water
supply meet the above requirements.
2. Start up: turn on the power switch. After
power-on, the machine begins to make ice