Commercial Undercounter Ice Maker User Manual for Installation and Maintenance Models: CIM-210 CIM-280 Thank you for purchasing a KoolMore product! If you are having trouble with your unit, for assembly assistance, missing or damaged parts. Please contact customer service Phone: 718-576-6342 Email: support@koolmore.com We are here to help.
Table of Contents Important Information ............................................................................................................................................................. 2 Warning and safety instruction.............................................................................................................................................. 4 General .................................................................................................................................
The label indicates a hazardous voltage. There is a risk of electric shock. The label indicates a hazardous voltage. There is a risk of electric shock. The label indicates rotating components inside. There is a risk of serious mechanical injury. The label indicates a flammable foaming agent “Cyclopentane” used. There is a risk of fire. The label indicates a flammable refrigerant “R290” used.
Warning sign, special attention is required.
Warning and safety instruction This ice machine is not intended for use by children, and those with physical weakness, slow response, or mental disorders.. The ice machine must be placed on the floor sufficient to supports its weight. Insufficient base may cause the equipment fall over and cause injury. This ice machine is not intended for use by children. There should be sufficient ventilation space around the ice machine. Keep good ventilation.
DANGER – RISK OF FIRE OR EXPLOSION. FLAMMABLE REFRIGERANT USED. TO BE REPAIRED ONLY BY TRAINED SERVICE PERSONNEL. DO NOT PUNCTURE REFRIGERANT TUBING. CAUTION – RISK OF FIRE OR EXPLOSION. FLAMMABLE REFRIGERANT USED. CONSULT REPAIR MANUAL/OWNER'S GUIDE BEFORE ATTEMPTING TO SERVICE THIS PRODUCT. ALL SAFETY PRECAUTIONS MUST BE FOLLOWED. CAUTION – RISK OF FIRE OR EXPLOSION. DISPOSE OF PROPERLY IN ACCORDANCE WITH FEDERAL OR LOCAL REGULATIONS. FLAMMABLE REFRIGERANT USED.
Schematic Diagram of Installation NPT THREADS
Installation Steps 1. Check if the ice machine is in good condition and the accessories are complete; check the machine model and the machine nameplate. 2. Open the bin door and remove the packaging tape from the ice thickness sensor and the flap. They are used to avoid possible damage during transportation only. 3. Clean the ice bin and the food area inside with a sponge soaked in warm water and soap. Then wash and dry it with potable water. 4.
temperature of the evaporator and the ice making water is gradually decreasing; The fan is running normally, and there is stable air flow in the inlet and outlet of the ice machine; The ice machine has no abnormal noise; It takes about 10 to 20 minutes to make one batch ice, depending on the ambient temperature and the temperature of the water. The higher the temperature is, the longer the ice making will take; Ice cube can be properly defrosted from the machine.
Instruction of Control Panel 1. LED Display: Self-check: Display “ini” code. Preparing: Counts second upward Ice making: Counts seconds upwards prior the water reaching 32 degree F. Counts seconds downwards to 0 seconds afterwards. Ice Harvest: Counts seconds upwards. Clean: Displays “CLE” during cleaning and descaling; Displays “STL” during sterilizing; Displays “rin” during rinsing. making process. Note: All cleaning and sanitizing chemicals used must be nickel safe 5.
Code Error Machine Status Protective shutdown recover E01 Water Curtain failure or Ice Full Switch E03 Ice Harvest Overtime Protective shutdown E04 High Temperature Protective shutdown E05 Water Shortage Fault E06 High Pressure E07 Contestation Sensor Open Circuit Error light comes on every 5 E08 Condensation Sensor Short Circuit Error light comes on every 5 E13 Water Level Control failure Protective shutdown after the water curtain is reset Protective shutdown and retry every 30 mi
Maintenance Note: Maintenance must be done by a qualified professional personal. Warning: Before maintenance or manual clean, be sure to cut off the water source and power supply. Exterior cleaning Frequently clean the environment around the ice machine to keep it clean. Do not block the vents. For the air-cooled ice maker, the condenser should be cleaned every three weeks.
“clean” button again, the ice maker will do auto sterilizing for about 15 minutes. Please do spray sterilizing to the evaporator at the mean time to insure a complete sterilizing. When finished, the ice maker will get into rinsing process; the process will take about 25 minutes. manually followed by the clean and sterilizing process instruction. Push the “clean” button again, the ice maker will do auto clean for about 15 minutes. Please spray clean the evaporator to insure a complete clean.
Service Call If the ice machine works abnormally, please confirm below before making a service call: 1. Check the water supply whether there is water in the water trough; whether the water pressure for the ice machine is 1 18.75 psi to 80 psi; the water temperature is 40-90°F; whether the water valve is open; whether there is no water leakage; 2.
Water leaking Check and correct the inlet water filter Inlet water filter has not been replaced for a long time Too slow in ice making The condenser or air filter is dirty High ambient temperature Poor ventilation Water temperature is too high Clean the condenser and filter screen Normal working temperature range of 41-95°F Check the environment around the ice machine Check the water supply temperature of 41-95°F Too much noise The ice machine is not placed Level the ice machine in a leveled foundatio
If you are experiencing any issue with your unit, please contact us right away. Phone: 7 1 8 -576-6342 Email support@koolmore.com Limited Service Warranty Valid only in the Continental United States 1 Year Parts and Labor Warranty Unless otherwise stated, Koolmore Supply Inc warrants to the original purchaser of new Koolmore Ice machines , that such equipment will be free from defects in material and workmanship for a period of 1 year from the date of delivery.
For Warranty Inquiries or Service: This warranty is only valid on equipment purchased from an authorized dealer. Locate the model number on the rating label Next, call 1-718-576-6342. You must have the model number when contacting service technicians.