User Manual

8
Manually testing cables
1. Plug the banana plugs of the leads into the corresponding red and black jacks on the front
panel of the cable tester.
2. Touch each lead to the corresponding pin on either end of the cable.
3. A lit LED accompanied by a beep indicates good connectivity and continuity.
Using test tones
1. Switch the Cable Test/Tone Test selector on the receiver to the Tone Test position. The power
LED will glow red.
2. Insert one of the connectors of the cable into the appropriate jack on the CBT-MF.
3. Select the amplitude of the test tone on the tone test volume selector (+0 dB, -10 dB,
or -50 dB.)