User's Manual

Installing and Removing Board Options and Drives 6-1
Installing and Removing
Board Options and Drives
Chapter 6Chapter 6
Chapter 6Chapter 6
Chapter 6
Installing and Removing
Board Options and Drives
This chapter describes how to install and remove optional drives and board options
in your computer. You can use these instructions to install and remove a variety of
devices and board options. Although your board options and drives may look a bit
different from the ones illustrated here, you can install and remove it the same way.
See Chapter 5 for removing and replacing the cover.
NOTE
Turn off the computer. Then disconnect the computer from its power source and
from any telecommunications links, networks, or modems before performing any of
the procedures described in this chapter.
Installing an Expansion Card
This section explains how to install an expansion card in your computer. Your
computer has three 32-bit PCI and one AMR connectors.
Follow the below steps to install an expansion card.
1. Remove the system cover according to the instructions in "Removing the Cover"
in Chapter 5.
2. Insert a flat blade screwdriver into a hole of the slot cover you wish to remove.