User's Manual

Using Your Computer 3-3
CAPTUER 3
Using a CD/DVD-ROM Drive
To use CD/DVD ROM drive, turn on your system and then press the load/eject
button. When the disk tray pops out, put CD/DVD title in the tray with the label side
up. Press the load/eject button again or gently push the disk tray to close it. During
the procedure, the busy indicator will flash.
If you want to remove the CD/DVD title, make you sure that the busy indicator is
off. Press load/eject button, and then remove CD/DVD title when the disk tray pops
out. Press load/eject button again to close the tray.
NOTES
When your system is turned off, you may need to open the CD/DVD tray. At this
time, insert a fine rod such as an opened paper clip into the emergency eject hole as
far as it will go. When the tray is slightly open, carefully pull it out.
Your computer references the CD/DVD-ROM drive as D: unless you have more
than one hard disk drive or partition. Then it automatically recognizes it as the
next available drive letter.
The high speed DVD-ROM drive (above 6x) may take few seconds to stop the
running of the spindle motor when you press the eject button, immediately after
using CD or DVD title, to open the tray. Wait about 5 to 10 seconds after pressing
the eject button to give the DVD drive sufficient time to stop the running of the
spindle motor and eject the tray.