User Manual

20
INT knob [−511...0...+511]
Species the intensity of the EG.
Turning the knob to the right will increase the intensity.
TIP
When turning the INT knob while holding down the SHIFT buon,
the eect will move in a negative direction.
TARGET switch [PITCH, PITCH 2, CUTOFF]
Selects which parameter will be aected by the EG.
PITCH: The EG will aect the PITCH of VCO 1 and VCO 2.
PITCH 2: The EG will aect the PITCH of VCO 2.
CUTOFF: The EG will aect the CUTOFF of the FILTER.
LFO
LFO: Low Frequency Oscillator
The LFO (low-frequency oscillator) is
used to make cyclical changes in the
pitch and volume of the sound.
Depending on its target, the LFO
can provide vibrato (PITCH); Tonal
changes to the Oscillators (SHAPE); or Wah-Wah (CUTOFF) eects.
WAVE switch [ , , ]
The LFO can be set to a sawtooth wave ( ), a triangle wave ( ), or a square
wave (
).
MODE switch [FAST, SLOW, 1-SHOT]
Species the range of change and action for the LFO frequency.
FAST: The range of speed for the LFO frequency will be from 0.5 Hz–2.8 kHz.
SLOW: The range of speed for the LFO frequency will be from 0.05 Hz–28 Hz.
1-SHOT: The LFO will stop one half-cycle after a sound is made. The range of
speed for the LFO frequency will be from 0.05 Hz–28 Hz.