User Manual

COMBI
0
123456789
33
2. Combination mode
COMBI PAGE MENU
For details on how to select pages in Combination mode,
refer to p.1.
COMBI 0: Play
In this display page you can select and play Combinations.
A Combi allows you to use up to 8 programs at one time.
0–1: Combi (Combination)
X50
microX
0–1a: Bank, Combi Select, Category,
Cat.Hold, 10’s Hold,  (Tempo)
Bank (Bank Select) [Bank A…C]
This is the Combination bank display.
On this instrument, there are a total of 384 combination pro-
grams in three rewritable banks (A, B, C), each containing
128 combinations.
X50: Use the front panel COMBI BANK [A]–[C] buttons to
select the bank.
microX: Use the front panel COMBINATION [A]–[C] but-
tons to select the bank. If you press one of the COMBINA-
TION [A]–[C] buttons, you will automatically enter
Combination mode regardless of the mode in which you
were.
Combi Select (Combination Select)
[0...127: name]
Here you can select a combination. Choose this parameter,
and use one of the following methods to select a combina-
tion.
X50:
• Turn the [VALUE] dial.
• Use the [INC][DEC] buttons.
• Use the numeric buttons [0]–[9] to enter a program
number, and press the [ENTER] button to finalize the
number.
Play 0: Play Select and play combinations.
Select a program for each timbre, and
make, pan and level settings.
Select an arpeggio pattern and make
settings.
microX: Select an external control set.
(☞p.33)
Tone Adjust 1: Ed–Tone Adjust Select the program used by each timbre.
Specify the pan and volume of each pro-
gram.
Use Tone Adjust to adjust parameters.
(☞p.38)
Track Parameter 2: Ed–Track Param MIDI, OSC, Pitch, delay, and scale set-
tings for each timbre. (☞p.40)
MIDI Filter 1 3: Ed–MIDI Filter1 MIDI message transmission/reception fil-
ter settings for each timbre, such as Prog
Change, JS, Ribbon and After Touch.
(☞p.42)
MIDI Filter 2 4: Ed–MIDI Filter 2 MIDI message transmission/reception fil-
ter settings for each timbre, such as
REALTIME CONTROL Knob, SW, and
Other Ctrl Change (☞p.44)
Key Zone 5: Ed–Key Zone Key zone settings for each timbre.
(☞p.45)
Velocity Zone 6: Ed–Vel Zone Velocity zone settings for each timbre.
(☞p.46)
Arp/Controls 7: Ed–Arp/Ctrls Arpeggiator settings. (Same as the 0:
Play parameters; can be edited from
either page.)
Controller settings. (☞p.47)
Insert Effect 8: Ed–InsertFX Bus and master effect send level settings
for each timbre.
Insert effect routing, selection, and set-
tings. (☞p.50)
Master Effect 9: Ed–MasterFX Master effect selection and settings.
Master EQ settings. (☞p.52)
Bank A
Preloaded combinationsBank B
Bank C
0–1a
0–1b
0–1a
0–1b