User Manual

237
Sound Edit
Basic: EQ
Reference
Basic: EQ
In this page, you can set the semi-parametric three-band equal-
izer for the selected oscillator.
Enable
Check this box to activate the equalizer on the selected oscillator.
TRIM
This knob allows you to limit the level of the signal passing
through the equalizer. Extreme equalization values can overload
the audio circuits and lead to distortion. This control lets you set
equalization as desired, and at the same time avoid overloading.
0…99 Limiting value. The higher, the most effective it
is.
Low Gain
Low frequencies equalization. This is a shelving curve filter. Val-
ues are shown in decibels (dB).
-18…+18dB Low gain value in decibels.
Mid (Middle) Gain
Middle frequencies equalization. This is a bell curve filter. Values
are shown in decibels (dB).
-18…+18dB Middle gain value in decibels.
Mid (Middle) Freq
Centre frequency of the middle frequencies equalization.
-0.100…+10 kHz
Centre frequency in kHz.
Hi (High) Gain
High frequencies equalization. This is a shelving curve filter.
Values are shown in decibels (dB).
-18…+18dB High gain value in decibels.
DrumKit: Sample Setup (Drum Kits)
This page appears when you edit a Drum Kit. Here you can
select a different percussive sample for each key and layer.
Drum Kits use only one oscillator.
Key
Key
Key in edit. To select a key, you can press a key on the keyboard
while this parameter is selected.
Layers
Number of layers assigned to the selected key. Depending on the
number of selected layers, you can have a different number of
velocity switches.
Assign
Use this parameter to turn the sample on/off.
On The sample is assigned to the selected key.
Off The sample is not assigned. The sample assigned
to the next highest assigned key is used instead.
Layer Selector & Velocity Sample Switch
Selected Layer
Use these radio buttons to select the layer to edit. The available
layers depends on the “Layers” parameter.
Velocity Switches
Each of these values separates the two adjacent layers for the
selected sample/key. Notes stricken harder than a velocity switch
will be played by the layer on the right, while notes stricken
softer are played by the layer on the left.
The first and last values are not editable, and are always 001 and
127 (respectively).
Drum Sample
Bank/Num/Name
Use these parameters to select a different Drum Sample for each
layer. You can use velocity to switch between the available sam-
ples. Offset and Level can be adjusted independently for the var-
ious drum samples.
Selected
Layer
Velocity
Switches
Pa300 User Manual v150 (English).book Page 237 Saturday, March 29, 2014 5:29 PM