User Manual

303
Effects
Chorus, Flanger, and Phaser (Cho/Fln Phaser)
Appendix
34: St. Random Flanger
(Stereo Random Flanger)
The stereo effect uses a step-shape waveform and random LFO
for modulation, creating a unique flanging effect.
35: St. Env. Flanger
(Stereo Envelope Flanger)
This Flanger uses an envelope generator for modulation. You
will obtain the same pattern of flanging each time you play. You
can also control the Flanger directly using the modulation
source.
c: Sweep Mode
c: Src
This parameter switches the flanger control mode. With “Sweep
Mode” = EG, the flanger will sweep using the envelope genera-
tor. This envelope generator is included in the envelope flanger,
and not related to the Pitch EG, Filter EG, or Amp EG.
The “Src” parameter selects the source that starts the envelope
generator. If you select, for example, Gate, the envelope genera-
tor will start when the note-on message is received.
When “Sweep Mode” = D-mod, the modulation source can con-
trol the flanger directly. Select the modulation source using the
“Src” parameter.
The effect is off when a value for the modulation source specified for
the “Src” parameter is smaller than 64, and the effect is on when the
value is 64 or higher. The Envelope Generator is triggered when the
value changes from 63 or smaller to 64 or higher.
d: EG Attack
d: EG Decay
Attack and Decay speed are the only adjustable parameters on
this EG.
a
Delay Time
[msec]
0.0...50.0
Sets the delay time from the original
sound
b
LFO Waveform
Step-Tri,
Random
Selects the LFO Waveform
LFO Phase
[degree]
–180...+180
Sets the LFO phase difference
between the left and right
c
LFO Frequency
[Hz]
0.02...20.00 Sets the speed of the LFO
Src Off...Tempo
Selects the modulation source used
for both LFO speed and step speed
Amt
–20.00...
+20.00
Sets the modulation amount of LFO
speed
d
LFO Step Freq
[Hz]
0.05...50.00
Sets the LFO step speed (speed that
changes in steps)
Step Amt
–50.00...
+50.00
Sets the modulation amount of LFO
step speed
e
MIDI Sync Off, On
When this is on, the LFO speed is set
by BPM, Base Note, and Times,
instead of Frequency
BPM
MIDI,
40.00...
300.00
MIDI syncs to the system tempo; 40–
300 sets the tempo manually for this
individual effect
Base Note r...w
Selects the type of notes that
specify the LFO speed
Times x1...x32
Sets the number of notes that
specify the LFO speed
f
Step Base Note r...w
Selects the type of notes to specify
the LFO step speed
Times x1...x32
Sets the number of notes to specify
the LFO step speed
g Depth 0...100
Sets the depth of LFO
modulation
h
Feedback –100...+100
Sets the feedback amount
High Damp [%] 0...100
Sets the feedback damping amount
in the high range
i
Wet/Dry
-Wet, -
1:99...Dry...99:1
, Wet
Balance between the wet and dry
signal
Src Off...Tempo
Table , “Dynamic Modulation
sources,” on page 283
Amt –100...+100 Amount of modulation source
LFO: Step-Tri/Random
Left
Right
Feedback
LFO Phase
FX Amt
FX Amt
High Damp
Stereo In - Stereo Out
Flanger
Flanger
a
L Dly Bottom
[msec]
0.0...50.0
Sets the lower limit of the left-
channel delay time
L Dly Top
[msec]
0.0...50.0
Sets the upper limit of the left-
channel delay time
b
R Dly Bottom
[msec]
0.0...50.0
Sets the lower limit of the right-
channel delay time
R Dly Top
[msec]
0.0...50.0
Sets the upper limit of the right-
channel delay time
c
Sweep Mode EG, D-mod
Determines whether the flanger is
controlled by the envelope
generator or by the modulation
source
Src Off...Tempo
Selects the modulation source that
triggers the EG (when Sweep Mode =
EG), or the modulation source that
causes the flanger to sweep (when
Sweep Mode = D-mod)
d
EG Attack 1...100 Sets the EG attack speed
EG Decay 1...100 Sets the EG decay speed
e Feedback –100...+100
Sets the feedback amount
f High Damp [%] 0...100
Sets the feedback damping amount
in the high range
g
Wet/Dry
-Wet, -
1:99...Dry...99:1
, Wet
Balance between the wet and dry
signal
Src Off...Tempo
Table , “Dynamic Modulation
sources,” on page 283
Amt –100...+100 Amount of modulation source
EG Attack/Decay
EG
D-mod
Sweep Mode
D
-mod
Flanger
Flanger
Left
Right
Feedback
FX Amt
FX Amt
High Damp
Stereo In - Stereo Out
Pa300 User Manual v150 (English).book Page 303 Saturday, March 29, 2014 5:29 PM