User Manual
Table Of Contents
- Let’s start!
- Playing and singing
- The SongBook
- Customizing and editing the Sound sets
- Customizing, recording and editing the Styles
- Customizing, recording and editing the Songs
- Customizing and editing the Sounds
- Listening and customizing the Sounds
- Editing the Sounds
- Setting the Sound’s basic parameters
- Setting the oscillator’s basic parameters
- Programming the Damper pedal
- Equalizing the Sound
- Setting the Drum Kit’s basic parameters
- Equalizing the Drum Kit
- Mixing and retriggering the drum samples
- Modulating pitch
- Programming the pitch envelope (Pitch EG)
- Programming the filters
- Modulating the filters
- Programming the filter envelope (Filter EG)
- Programming amplitude and pan
- Modulating amplitude
- Programming the amplitude envelope (Amp EG)
- Programming the LFO
- Adding effects to the Sound
- Sound Edit utilities
- AMS (Alternate Modulation Sources)
- Writing the Sounds
- Managing the User Samples
- The Effects
- Effects for the MIDI Sounds
- Adapting reverb to the room size
- Effects list
- DMS (Dynamic Modulation Sources)
- Dynamics (Dynamic)
- EQ and Filters (EQ/Filter)
- Overdrive, Amp models, and Mic models (OD Amp Mic)
- Chorus, Flanger, and Phaser (Cho/Fln Phaser)
- Modulation and Pitch Shift (Mod./P.Shift)
- Delay
- Reverb and Early Reflections (Reverb ER)
- Mono-Mono Serial (Mono-Mono)
- Double Size
- Limiter, Master EQ
- Effects for the MIDI Sounds
- Global settings, Preferences
- MIDI Connections
- MIDI
- Introduction to MIDI
- Quick settings using MIDI Presets
- MIDI communication settings
- Synchronizing Tempo with other instruments
- Programming the MIDI channels
- Installing the KORG USB MIDI Driver
- Connecting HAVIAN 30 to a personal computer or tablet
- Control Change messages
- Controlling the Styles and Player via MIDI
- MIDI
- File management
- Managing files
- Overview on file management
- Loading musical resources and settings
- Saving musical resources and settings
- Copying files and folders
- Deleting files and folders
- Selecting more items at once
- Formatting storage devices
- Backing up and restoring musical resources
- Connecting the internal drive to a personal computer
- Storage device management
- Exporting playlists
- Care of storage devices
- Managing files
- Appendix
150| Advanced editing of the Sound sets
Choosing the effects and setting their controls
Access the FX A/B Config page
1 Go to the Effects > FX A/B Config page.
2 Use the side tabs on the right to choose an FX Group.
Choose an effect for each FX processor
▪ Use the relevant pop-up menu to choose the effect assigned to the Master
FX1 or Master FX2 processor (inside the selected FX Group).
Usually, FX1 are reverbs, while FX2 are modulating effects (chorus, flanger,
delay…). See the dedicated chapter for a list of the available effects.
Mix the direct and effected signal inside the FX processors
▪ Use the W/D (Wet/Dry) parameter to set the balance between the Wet (ef-
fected) and Dry (direct) signal inside the corresponding FX processor.
Choose a modulating track
You can modulate one of the effect parameters by using MIDI messages gen-
erated by the internal physical controllers.
▪ Use the M.T. (Modulating Track) parameter to choose a track as a source of
the modulating MIDI messages.