User Manual
Table Of Contents
- Let’s start!
- Playing and singing
- The SongBook
- Customizing and editing the Sound sets
- Customizing, recording and editing the Styles
- Customizing, recording and editing the Songs
- Customizing and editing the Sounds
- Listening and customizing the Sounds
- Editing the Sounds
- Setting the Sound’s basic parameters
- Setting the oscillator’s basic parameters
- Programming the Damper pedal
- Equalizing the Sound
- Setting the Drum Kit’s basic parameters
- Equalizing the Drum Kit
- Mixing and retriggering the drum samples
- Modulating pitch
- Programming the pitch envelope (Pitch EG)
- Programming the filters
- Modulating the filters
- Programming the filter envelope (Filter EG)
- Programming amplitude and pan
- Modulating amplitude
- Programming the amplitude envelope (Amp EG)
- Programming the LFO
- Adding effects to the Sound
- Sound Edit utilities
- AMS (Alternate Modulation Sources)
- Writing the Sounds
- Managing the User Samples
- The Effects
- Effects for the MIDI Sounds
- Adapting reverb to the room size
- Effects list
- DMS (Dynamic Modulation Sources)
- Dynamics (Dynamic)
- EQ and Filters (EQ/Filter)
- Overdrive, Amp models, and Mic models (OD Amp Mic)
- Chorus, Flanger, and Phaser (Cho/Fln Phaser)
- Modulation and Pitch Shift (Mod./P.Shift)
- Delay
- Reverb and Early Reflections (Reverb ER)
- Mono-Mono Serial (Mono-Mono)
- Double Size
- Limiter, Master EQ
- Effects for the MIDI Sounds
- Global settings, Preferences
- MIDI Connections
- MIDI
- Introduction to MIDI
- Quick settings using MIDI Presets
- MIDI communication settings
- Synchronizing Tempo with other instruments
- Programming the MIDI channels
- Installing the KORG USB MIDI Driver
- Connecting HAVIAN 30 to a personal computer or tablet
- Control Change messages
- Controlling the Styles and Player via MIDI
- MIDI
- File management
- Managing files
- Overview on file management
- Loading musical resources and settings
- Saving musical resources and settings
- Copying files and folders
- Deleting files and folders
- Selecting more items at once
- Formatting storage devices
- Backing up and restoring musical resources
- Connecting the internal drive to a personal computer
- Storage device management
- Exporting playlists
- Care of storage devices
- Managing files
- Appendix
Adding effects |151
Feed the FX2 output back to the FX1 input
You can send the output of the FX2 processor (modulating effect) to the
input of the FX1 processor (reverb). This is preferred, for example, to send a
guitar amp simulator to the reverb.
▪ Use the MFX2 to MFX1 parameter to set the amount of the Master FX2 signal
to be sent back to the Master FX1 processor.
Editing the effects
Choose the effect to edit
1 Go to the Effects > Master 1 or Master 2 page.
2 Use the side tabs on the right to choose an FX Group.
Edit the parameters
▪ See the dedicated chapter for a list of all the Effects parameters and their
meaning.
Mix the direct and effected signal inside the FX processors
▪ Use the W/D (Wet/Dry) parameter to set the balance between the Wet (ef-
fected) and Dry (direct) signal inside the corresponding FX processor.
Choose the Dynamic Modulation Source
▪ Use the Src (Source) parameter to choose a modulation source (physical
controller or MIDI message).
See the chapter dedicated to the Effects for a list of all the Dynamic
Modulation Sources.