User Manual

13NC-Q1 SMART NOISE CANCELLING DJ HEADPHONES

Switching the ambient sound monitoring
You can switch between left and right ambient sound monitoring.
● Monitoring left or right ambient sound
• When ambient sound monitoring is off, touching the touch sensor for one second turns
on either left or right ambient sound monitoring. Again touching the touch sensor for
one second turns off ambient sound monitoring.
• To switch between left and right ambient sound monitoring, press and hold the SOUND
ENHANCING button on the right side of the unit to enter sound monitoring selection mode. In
selection mode, each press of the SOUND ENHANCING button switches between left and right
ambient sound monitoring. To exit selection mode, press and hold the SOUND ENHANCING button.
• While either left or right ambient sound monitoring is on, touching the touch sensor for
two seconds switches to both left and right ambient sound monitoring.
● Monitoring both left and right ambient sound
• When ambient sound monitoring is off, touching the touch sensor for two seconds
turns on both left and right ambient sound monitoring. Again touching the touch
sensor for two seconds turns off ambient sound monitoring.
• While both left and right ambient sound monitoring is on, touching the touch sensor
for one second switches to either left or right ambient sound monitoring.

Adjusting the monitoring EQ of the ambient sound
Press the SOUND ENHANCING button
on the right side of the unit to adjust the
monitoring EQ of the ambient sound.
• Repeatedly pressing the SOUND ENHANCING
button cycles through the settings in the
following order: High Boost
→
High Cut
→
Low Boost
→
Low Cut
→
Mid Scoop
→
Flat.
SOUND
ENHANCING

Adjusting the monitoring volume of the ambient sound
Use the ambient sound monitoring volume
controller on the right side of this unit to adjust
the monitoring volume of the ambient sound.
• (+): Increases volume
(–): Decreases volume
Cleaning
In order to enjoy continued use of this unit for a long time, regularly maintain
the various parts. Do not clean using solvents such as alcohol or thinner.
Cleaning the headphone body
●
Wipe the headphone body with a dry cloth.
●
If the charging connector or a control button gets wet, wipe it off
immediately. Otherwise, malfunction may result.
●
The headphone ear pads easily get dirty, so wipe them frequently to keep
them clean. Leaving bodily or other oily residue on the ear pads will cause
them to deteriorate quickly.
●
Since the sound-producing parts of this unit are delicate, do not touch or
blow on them or expose them to wind. Otherwise, malfunction may result.
●
If the charging cable becomes dirty, wipe it with a dry cloth. Continuing to
use the cable while it is dirty may cause it to deteriorate and malfunction.
Replacing parts

Replacing ear pads
If the ear pads are lost or become
unusable due to wear, replace them with
the separately sold accessory.
Pull off the old ear pad while rotating it
toward you for the left (L) side, or away
from you for the right (R) side, and then
attach the new ear pad by inserting the
four tabs as shown and rotating the ear
pad.
En