User's Manual

11
Touch control settings
The keyboard sensitivity, or touch, can be programmed.
Tochangetheseing,holddowntheTOUCHbuonand
pressthe+or–buonbesidethedisplay.
Display Touchcontrolseings
001 Light. Loud notes can be produced even by playing
lightly.
002 Normal. Normal piano touch.
003 Heavy. Loud notes can be produced only by play-
ing very hard.
004 Stable. Sensitivity variations are reduced, and a
relatively stable sound is produced.
005 Steady. Steady notes are produced, like with an
organ, regardless of the force used to press the key.
 Whentheinstrumentisturnedon,thetouchseingis
reset to 002 (Normal).
 Theseingsareappliedtoallsounds.
Transpose
Insomecases,asongmaybewrieninadicultkey(e.g.,
many black keys), or you may wish to shift the pitch to
match another instrument or vocalist. In such cases, you
can transpose (shift the pitch) so that you can use an easier
fingering, or use the same familiar fingering to play at a
dierentpitch.ThisiscalledtheTransposefunction.
Youcanshiftwithinarangeof11semitonessothatwhen
transposing upward by one semitone, playing the notes
shown at the left produces the pitches shown at the right.
When the instrument is turned on, the transposing is
reset.
While holding down the TRANSPOSE button, press the
keyboard key (F#6–F7) for the desired transposition.
If a keyboard key other than C7 is pressed, the TRANS-
POSE button lights up to indicate that the keyboard is
transposed.
The pitch of the entire keyboard is transposed according
to the pitch of the pressed keyboard key in relation to C7.
To return to the original pitches, hold down the TRANS-
POSEbuonandpresstheC7key.TheTRANSPOSEbut-
tonturnso,andtranspositioniscanceled.
Quiet
Loud
Quiet
Loud
Playing
strength
Loudness
002
001
003
004
005
Other functions
key Eect
F
#
6–B6 6–1 semitones below
C7 Standard pitch
C
#
7–F7 1–5 semitones higher
Function mode
The temperament as well as other pitch settings can be
speciedfromtheFunctionmode.
Setting procedure for functions in the Function
mode
1. PresstheFUNCTIONbuon.
TheFUNCTIONandPIANO1buonslightup.
2. Presstheappropriatebuonshownbelowtoselecta
parameter.
The pressed button lights up, and the current setting
appears in the display.
3. Pressthe+or–buontoselectaseing.
Pressing the + and – buttons simultaneously, the fol-
lowingseingscanberestoredtothedefaultseings.
•Pitch
•
Volumebalanceoflayermode
•Octave of layer mode
4. Afterspecifyingthedesiredsettings,pressthe
FUNCTIONbuontoreturntothemodeforplaying.
TheFUNCTIONbuonturnso.
When the D1 is turned off, all functions, except the
auto power-off function, return to their default set-
tings.
C4
C7
F7
F 6
Pitch
Temperament
Auto power-off
Volume balance of layer mode
Octave of layer mode
Pedal of layer mode