Music Production Station Owner's Manual
Table Of Contents
- Contents
- 1. Introduction
- 2. Front and rear panel
- 3. Basic operation (Quick Start)
- Conceptual diagram of the EM-1
- Listening to a Song
- Listening to Patterns
- Trying out the functions
- Changing the tempo of a song or pattern
- Pressing keys to play the sound of a Part
- Modifying (editing) the sound of a part
- Editing the effect or delay
- Playing the sound of a part along with a song or pattern
- Editing the sound of a part, effect, or delay while hearing a song or pattern
- Modifying (editing) a rhythm or phrase pattern
- Saving a pattern that you create
- Using a Motion Sequence
- Playing with Pattern Set
- Using the EM-1 as a tone generator module
- Synchronizing the playback with other ELECTRIBE models
- 4. Pattern mode
- Selecting a pattern
- Setting the playback tempo
- Playing a pattern (Pattern Play)
- Creating a pattern
- Motion sequence
- Convenient functions for editing patterns
- Transposing a phrase (Transpose)
- Moving data within a part (Move Data)
- Copying a part (Copy Part)
- Data Copy within a pattern
- Copying the sound of a part (Copy Sound)
- Erasing motion sequence data from the part, effect, or delay (Clear Motion)
- Erasing pattern data from a part
- Exchanging data between parts (Swap Part)
- Editing motion sequence data
- Pattern Set
- Saving a pattern (WRITE)
- 5. Song mode
- Selecting a song
- Setting the playback tempo
- Playing a song (Song Play)
- Creating a song
- Creating a song from scratch
- Specifying the Note of each pattern
- Editing a song
- Inserting a pattern at a specified position (Insert Pattern)
- Deleting a pattern from a specified position (Delete Pattern)
- Changing the pattern for a specific position
- Recording knob movements or your performance in a song (Event Recording)
- Deleting event data from a song
- Checking for song event data
- Saving a song (WRITE)
- 6. Global mode
- Metronome settings
- Synchronizing the EM-1 with external MIDI devices (MIDI Clock)
- Setting the MIDI channel of each part (MIDI ch)
- Setting the MIDI note number of a drum part
- MIDI filter settings
- Adjusting the pitch bend range
- Transmit/receive dump data
- Memory Protect (Protect)
- Saving your changes in Global mode (WRITE)
- 7. Appendices
- Index
7
1. Introduction
1. Introduction
Make connections and play!
Example connections
Preparing to play
Be sure to turn off the power before making connections. Careless operation may damage
your speaker system or cause malfunctions.
As shown in the above diagram, hook the AC adapter cable around the adapter cable holder.
When removing the cable from the holder, do not use excessive force.
1. Connect the included AC adapter to the DC 9V jack, and plug the adapter into an AC
outlet.
2. Connect one end of your audio cables to the line out jacks of the EM-1 (L/MONO, R), and
connect the other end to your mixer or powered monitor speakers (amplified speakers) etc.
If you will be listening in mono, use the L/MONO jack. To take full advantage of the EM-1's
sound quality, we recommend that you listen in stereo.
3. If you will be using headphones, connect them to the headphone jack.
The output from the line out jacks will not be switched off even if headphones are plugged in.
4. When you have finished making connections, turn on the power. Slightly raise the master
volume of the EM-1, and strike the Drum part keys (1...6B) to check whether connections
have been made correctly. Use the master volume of the EM-1 and the gain and fader con-
trols of your mixer or powered monitor system to adjust the volume to an appropriate
level.