Rhythm Production Sampler Owner's Manual
Table Of Contents
- Contents
- 1. Introduction
- 2. Front and rear panel
- 3. Basic operation (Quick Start)
- Conceptual diagram of the ES-1
- Listening to a Song
- Listening to a Pattern
- Listening to a Sample
- Trying out the functions
- Changing the tempo of a song or pattern
- Striking keys to play Parts
- Modifying (editing) the sound
- Editing the effect and delay settings
- Striking the part keys along with a song or pattern
- Editing the sound of a part, effect, or delay while hearing a song or pattern
- Modifying (editing) a rhythm pattern
- Saving a pattern you create (Write)
- Using a Motion Sequence
- Connecting various sources to the audio inputs
- Let’s record a sample
- About the Slice function
- About the Resample function
- Assigning a sample sound to a sample part
- Playing with Pattern Set
- Using the ES-1 as a tone generator module
- Synchronizing with an EA-1 or ER-1
- 4. Sample mode
- Recording a sample
- Selecting a sample
- Playing a sample
- Modifying a sample
- Specifying the start location
- Specifying the end location
- Specifying the fade-out length
- Directly sampling the sound of the ES-1 (Resampling)
- Slice
- Other functions for editing a sample
- Deleting a sample(Delete Sample)
- Checking the remaining amount of sampling area (Memory)
- Saving a sample (WRITE)
- 5. Pattern mode
- Selecting a pattern
- Setting the playback tempo
- Playing a pattern (Pattern Play)
- Creating a pattern
- Motion sequence
- Convenient functions for editing patterns
- Editing motion sequence data
- Pattern Set
- Saving a pattern (WRITE)
- 6. Song mode
- 7. Global mode
- 8. Appendices
47
5. Pattern mode
5. Pattern mode
Saving a pattern (WRITE)
If you wish to keep the pattern data that you create, you must
perform this Write operation. When you perform the Write op-
eration, "Data Copy within a pattern" (p.44) will occur auto-
matically, depending on the pattern length.
If you intentionally want to discard your edits and revert to the
original pattern data, simply select a different pattern without
Writing.
1. If the pattern is playing, press the Stop/Cancel key to stop
playback. Use the cursor keys to make the parameter select
LEDs indicate Pattern.
2. Press the Write key once (the key will blink). The pattern num-
ber will blink in the display.
3. Rotate the dial to select the writing destination pattern num-
ber.
4. Press the Write key once again to write the data.
To cancel, press the Stop/Cancel key.
3
2,4
If the Global mode Memory Protect setting is on, it will
not be possible to Write. In this case, you must turn off
the Global mode Memory Protect setting before you ex-
ecute the Write operation.
Never turn off the power during the Write operation. This
can damage the data.