User's Manual
18
10. Ensurethatthestandhasnogapsandisnottilted,andthat
allthescrewsaretightenedrmly.
11. Putcapsonthescrewheadsontherightandlesidepanels.
Caps
12. Connectthepedalcordandthespeakercordtotheconnec-
torsontherearoftheLP-380’sconnectorbox.
When connecting the pedal cord and the speaker cord, ob-
serve the correct orientations of the connectors.
The pedal cord or the speaker cord can be detached from the
connector with its locking tab held down.
Cord
holder
Speaker cord
Pedal cord
Speaker cord
Pedal cord
Locking tab
73-key version
13.Usethecordholdertoholdthepedalcord.
After securing the cord with the cord holder, ensure
that excess pressure is not applied to the connectors.
14.ConnectthededicatedcordtotheACadapter.Then,
plugtheACadapterintotheDCINconnector,and
wrapthecordaroundthecordhookofthepiano.For
details,referto“ConnectingthePower”onpage5.
15.PlacetheLP-380whereyouintendtouseit.Make
suretoplaceitinasafelocationwheretheoorisat
andstable.
Onthe73-keyversion,thepedalunitandstandare
separate,andonlythepedalcordisattachedtothe
stand.Becarefulwhenmovingthedigitalpianotoan-
otherlocation.
When seing the digital piano in place, make sure that
the stand does not rest on the AC adapter cable or pedal
cable.
For greater safety, be sure to attach the anti-tipping
brackets to the rear of the le and right side panels.
Check following assembly
□ Areanypartsleover?
If any parts are le over, carefully review the assembly proce-
dure to see where those parts should have been used.
□ Makesurethatallscrewsaretight.
5. Forthe88-keyversion,insertthepedalunitintothepedal
board,andthenfastenitbypressingapushrivetintothe
hole(abovethecutout)attherearofthepedalboard.
Aer pressing it into there, li the pedal board to check that
the pedals do not drop.
The push rivet will prevent the pedal unit from falling out.
Therefore, it cannot be fully fastened to the pedal board.
Thisstepisnotnecessarywiththe73-keyversion.
Front
Front of pedal board
Rear of pedal board
Rear
Push
Push rivet
6. Forthe88-keyversion,temporarilyfastenthepedalboard
(withthepedalunitattached)tothehardwareinsidethe
sidepanelsofthestand,usingfourscrews(M4).
Thisstepisnotnecessarywiththe73-keyversion.
Screws
(M4)
Screws
(M4)
7. Raisetheassembledstandslowlywithtwopeople.
8. Makesuretoaachtheanti-tippingbracketsbehindboth
sidepanels.Andtheanti-tippingbracketfastenedtothe
leofthecodeholderatthistime.
Joints between the side panels and the aached anti-tipping
brackets should be even (with no level dierence le).
Anti-tipping
Bracket
Screws (M4)
Screws (M4)
Reverse
Reverse
Cord holder
73-key version
9. Then,firmlytightenallthescrewsthataretemporarily
tightenedinstep3and6.
When tightening the screws on the LP-380, adjust the up/
down and front/rear positions on the le and right side pan-
els so that they are equal.