User Manual
21
RATE knob
[0...1023 / 1/8, 1/16, 1/32...1/1024, 1/2048 / 4, 2, 1, 0, 3/4...1/64]
The rate knob adjusts the speed of the LFO.
Turning the knob to the right will increase the LFO speed.
The values indicated here depend on the LFO BPM Sync (p.33) seings in the
PROGRAM EDIT mode, and the MODE switch, as shown below.
LFO BPM Sync MODE switch
O 0–1023
On FAST 1/8, 1/16, 1/32...1/1024, 1/2048
On SLOW, 1-SHOT 4–1/64
TIP
When the Parameter Disp of GLOBAL EDIT mode is set to All, you
can see the value (“Parameter Disp”, p. 43).
INT knob [0...1023]
The INT knob adjusts the intensity of the LFO.
Turning the knob to the right will increase the LFO intensity.
TIP
When turning the INT knob while holding down the SHIFT buon,
the eect will move in a negative direction.
TARGET switch [PITCH, SHAPE, CUTOFF]
Selects the parameter where the LFO modulation will be applied.
PITCH: Modulation is applied to the VCO 1, 2 PITCH.
SHAPE: Modulation is applied to the VCO 1, 2 SHAPE.
CUTOFF: Modulation is applied to the FILTER CUTOFF.