User Manual
26
Editing sequence data (step edit)
With step edit, you can change and adjust notes, slides and motion sequences
in the sequence data you record.
1.
Select the program that includes the sequence data you wish to edit.
2.
Edit the sequence data using the MOTION/SLIDE/NOTE switch and but-
tons 1–16.
When the MOTION/SLIDE/NOTE switch is set to NOTE
Pressing buons 1–16 will turn the notes recorded for the corresponding
steps on (the buon will light) or o (the buon will go dark). For steps
that are turned on, the corresponding notes will play; and for steps that are
turned o, the corresponding notes will not play (rest). If a note has not
been recorded for a step, it cannot be turned on.
Hold down a buon and press a key to input a note on the corresponding
step. Holding down adjacent buons together and then pressing a key will
tie the notes belonging to those steps together.
TIP
To adjust the gate time for the corresponding steps, turn the PRO-
GRAM/VALUE knob while holding down the buons.
When the MOTION/SLIDE/NOTE switch is set to SLIDE
Pressing buons 1–16 will turn the slide for the corresponding steps on (the
buon will light) or o (the buon will go dark).
When SLIDE is on for a particular step, a slide eect will be heard from
that step to the next step. The intensity of the slide eect can be adjusted in
PROGRAM EDIT mode. For details, refer to “Slide Time” (p. 31).
When the MOTION/SLIDE/NOTE switch is set to MOTION
“MOTION VIEW” will be shown on the display, and the motion that is
saved to the program will be graphically displayed.
Pressing buons 1–16 will turn the motion for the corresponding steps on
(the buon will light) or o (the buon will go dark). If motion has not
been recorded for a step, it cannot be turned on.
12345678910 11 12 13 14 15 16
2
2
1