User Manual

If the parameter value does not change

In some cases, the parameter value may not change or Motion Sequence

recording may not start, even when you turn the knob. This means that the

knob mode is set to “Catch”.

In this case, the actual value of the parameter you’re editing (the value

shown in the display) will not change unless it matches the position of the

knob. In Catch mode, the knob position and the value will be linked only

after the knob position reaches the actual value. This prevents an unnatural

change in sound that is caused when a value suddenly changes.

Let’s say that you’ve turned the knob to edit a certain parameter,

and that the knob is in the position shown.

The actual value of the parameter is at the position shown by the

triangle.

The parameter value will not change until the knob position

reaches the triangle mark.

Once the knob has reached the position corresponding to the

actual value, the parameter value and the knob position will be

linked, and the value will change as you turn the knob.

Audio In [O, On]

The audio input jack can be globally enabled or disabled.

O: Any audio signals coming into the jack will be muted.

Local SW [O, On]

The local connection makes a link between the monologue keyboard the

sound-generating circuitry. Normally, this link is On. However, if you are us-

ing the monologue with an external sequencer or sequencing software, you

will want to set the local connection to O to eliminate the double-triggering of

notes caused by MIDI echo.

O: The monologue’s keyboard will be internally disconnected from the tone

generator.