User Manual
42
Button 6 (GLOBAL 4)
These parameters relate to the monologue’s MIDI capabilities.
MIDI Ch [1...16]
In order to communicate, the monologue and your other MIDI devices must be
set to the same MIDI channel. This is both the Transmit and Receive channel.
Clock Source [Auto (USB), Auto (MIDI), Internal]
Many features of the monologue can be sync’d to the tempo or BPM. This pa-
rameter allows you to specify whether the clock source is internal, or an exter-
nal MIDI Clock Source.
Auto (USB), Auto (MIDI): When there is no input, the internal clock will be
used; and when input is detected, the internal clock will be synchronized to the
clocks from the USB B and MIDI IN connectors respectively.
Internal: Only the internal clock to be used.
When a cable is plugged into the SYNC IN jack, the internal clock is
synchronized to the SYNC IN jack clock, regardless of the MIDI clock
seings.
Enable Rx MIDI [O, On]
Sets whether MIDI channel messages can be received or not.
En Rx Transport [O, On]
Sets whether Transport-related MIDI system real-time messages (start, stop,
continue) can be received or not.
Enable Tx MIDI [O, On]
Sets whether MIDI channel messages can be transmied or not.
MIDI Route [USB+MIDI, USB]
MIDI signals can be sent and received via the MIDI and USB connectors, or by
the USB connector alone.
USB+MIDI: MIDI messages are received via the USB B connector and the MIDI
IN connector; messages are transmied from the USB B connector and the
MIDI OUT connector.
USB: MIDI messages will be transmied and received only via the USB B con-
nector. When using the USB connector as a MIDI interface, it is advantageous
to use this seing.