User Manual
9
Playing Programs and Sequences
Selecting and Playing a Program
The monologue comes equipped with 100 Programs. Of those, 80 are ready-to-
play preset Programs and 20 locations are available to save your own sounds
and custom edits.
Each Program includes seings for the sound, as well as sequence data seings.
1.
Enter the Play mode.
When the monologue is turned on, it will automatically enter the Play
mode.
In the Play mode, verify that the EDIT MODE buon on the front panel are
unlit.
TIP
If the EDIT MODE buon is lit, press the EXIT buon. The PLAY or
REC buons will light to indicate when the sequence data saved in a
Program is being played back or is recording. You can still select other
Programs in this state, but press the PLAY buon if you wish to stop
the Sequencer.
2.
Turn the PROGRAM/VALUE knob to select a Program.
The display will indicate the Program name and number.
The monologue comes with 80 preset Programs (001–080) as part of the fac-
tory preload data. These preset Programs are instantly accessible and ready
for you to enjoy. For details, refer to “Program List” (p. 54).
TIP
Hold down the SHIFT buon while turning the PROGRAM/VALUE
knob to skip through the Program List in increments of 10.
TIP
In addition to showing Program name and number, the display can
also be used as an oscilloscope, to show the electrical signals created
by the waveform of the sound. When SLIDE or NOTE is selected us-
ing the MOTION/SLIDE/NOTE switch, the waveform will be dis-
played.
1
Make sure EDIT MODE button is unlit.
2