Operation Manual

592| Effects for the Sounds, Voice, Guitar
Classic Chorus
This models a famous chorus unit that was built into a guitar amp. Although
it does not provide a chorus and vibrato select switch, you can use the “Wet/
Dry” and “Bus” settings to produce their effect. The “Speed,” “Depth,” and
“Manual” parameters allow an even wider range of sounds than the original
unit.
Left
Right
Wet / Dry
Wet / Dry
Wet: Mono In - Stereo Out / Dry: Stereo In - Stereo Out
+
Chorus
LFO
Output Mode
Mono
Stereo
(L-D&R-W)
a Speed [Hz] 0.10…10.0 Sets the LFO speed
Src Off…Tempo Modulation for the chorus speed. See the
list of DMS (Dynamic Modulation Sources)
at the beginning of this part
Amt –10.00…
+10.00
Sets the modulation amount of the chorus
speed
b Depth 1…100 Sets the depth of LFO modulation
Src Off…Tempo Modulation for the chorus depth. See the
list of DMS (Dynamic Modulation Sources)
at the beginning of this part
Amt –100 … +100 Sets the modulation amount of the chorus
depth
c Manual 0…99 Sets the delay time for chorus. If Depth is
set to 100, Manual will not function.
d Output Mode Mono, Stereo
( L- D r y & R - W e t )
The output mode switches between vibra-
to and chorus. Mono is a vibrato, Stereo is
a chorus.
e Wet/Dry Dry, 1:99 … 99:1, Wet Balance between the wet and dry signal
Src Off…Tempo Selects a modulation source for Wet/Dry
Amount –100 … +100 Sets the modulation amount for Wet/Dry