Quick Start Guide

16| Let’s start!
Connecting the audio outputs
Use the AUDIO OUT connectors to send the audio output to a mixer, a set of
powered monitors, or an audio amplification system. These are unbalanced
(TS) 6.35 mm, or 1/4”, jack connectors.
When using a home audio amplifier, connect the other end of the cable to the
CD, LINE IN or TAPE/AUX input of your audio system. Don’t use the PHONO
inputs of your audio system!
Use either the LEFT or RIGHT connector to output a mono signal.
Adjust the output level with the MASTER VOLUME knob.
If they are not deactivated, the integrated speakers will work in parallel with
the main audio outputs.
Installing the music stand
A music stand comes with your Pa700. Insert its legs into the two dedicated
holes on the rear panel, as shown in the following illustration. Please note
that the latest 0,5 cm (0.2”) require more strength to fit. Push harder, until
you feel a ‘click’ and the legs are completely inserted.