Operation Manual

Listening and customizing the Sounds |381
Setting the Voice mode
▪ Use the Poly and Mono radio buttons to choose whether the Sound will play
polyphonically (playing chords) or monophonically (one voice at a time).
▪ Use the Legato checkbox to activate legato to a mono voice.
Legato will make the second note’s attack smoother. Envelope and LFO will
not be retriggered. This is particularly effective with wind instrument and
analog synth-type sounds.
▪ Turn on the Hold parameter to keep the notes sustained even after releasing
the keys.
Mixing the effects
Sounds are sent to two Master FX processors (MFX 1 and MFX 2). The first
one is usually a reverb, the second a modulating effect.
▪ Use the On/Off switch to turn on or off the corresponding effect.
▪ Use the Send knob to adjust the level of the dry sound sent to the corre-
sponding effect.
▪ Use the Amount knob to mix between the dry and effected signal.
Writing the Sound
▪ When finished editing the Sound parameters in the main page of the Sound
mode, choose the Write Sound command from the page menu to save the
Sound. More details on writing Sounds at the end of this section.