Operation Manual

Editing the Sounds |439
When Intensity has a positive (+) value, a setting of + for this parameter will
allow the AMS to raise the EG level, and a setting of – will allow AMS to lower
the EG level. With a setting of 0 there will be no change.
Amp 1 EG changes (Level) (AMS=Velocity, Intensity = a positive (+) value)
Note-on
Note-off
Note-on
Note-off
Note-on
Note-off
Softly played note when Start Level
Swing=0 and Attack Level Swing
and Break Level Swing are set to +
Strongly played note when Start Level
Swing=0 and Attack Level Swing and
Break Level Swing are set to +
Strongly played note when Start Level
Swing=0 and Attack Level Swing and
Break Level Swing are set to +
Modulating the Amp EG times
▪ Use the Time Modulation > AMS 1/2 parameters to select a modulation
source for the Time parameters of the Amp EG.
▪ Use the Time Modulation > Intensity parameters (-99…+99) to specify the
depth and direction of the effect that the AMS will have on the Time param-
eters. With a setting of 0, the Amp EG times will be just as specified by the
Time settings.
For example, if the AMS is Amp KTrk +/+, the (Amp) Keyboard Track settings
(in the Edit Sound > Amp > Amp Mod page) will control the EG Time param-
eters. With positive (+) values of this parameter, positive (+) values of Ramp
(Ramp Setting) will cause EG times to be lengthened, and negative (–) values
of Ramp (Ramp Setting) will cause EG times to be shortened. The direction
of the change is specified by the At (Attack Time Swing), Dc (Decay Time
Swing), Sl (Slope Time Swing), and Rl (Release Time) parameters.
If the AMS is set to Velocity, positive (+) values of this parameter will cause
EG times to lengthen as you play more strongly, and negative (–) values will
cause EG times to shorten as you play more strongly. With a setting of 0, the
EG times will be as specified by the Level parameters.
▪ Use the At (Attack Time Swing), Dc (Decay Time Swing), Sl (Slope Time
Swing) and Rl (Release Time Swing) parameters to specify the direction
in which the AMS will affect the Time > Attack, Decay, Slope and Release
parameters.