Operation Manual

564| Effects for the Sounds
44 Effect parameters
REV (Reverbs)
O–verb
The O-verb features a high-quality, diffusion-based reverb core. In addition
to setting the size of the room, you can model its shape and materials by
adjusting the diffusion characteristics of both the initial reflections and the
main reverberant wash, and via separate controls for the high, mid, and low
decay times. The O-verb also includes randomization, for richer and smooth-
er reverb timbres.
Left
Right
Wet / Dry
Wet / Dry
Wet: Mono In - Stereo Out / Dry: Stereo In - Stereo Out
EQ Trim
+
EQ Trim
Pre Delay Input Diffuser
Pre EQ
Reverb
LFO: Sine
a Trim 0…100 Sets the EQ input level.
b Band1 Enable On, Off There are two fully parametric bands of
peaking EQ, for adjusting the reverb tim-
bre. These affect only the reverb, and not
the dry signal. Both bands have identical
parameters.
Band1 Fc [Hz] 200…20.00k
Band1 Q 0.5…10.0
Band1 Gain [dB] -18.0…+18.0
c Band2 Enable On, Off
Band2 Fc [Hz] 200…20.00k
Band2 Q 0.5…10.0
Band2 Gain [dB] -18.0…+18.0